1. Copy data from source vCenter Server to target vCenter Server
1. Copy data from source PSC to target PSC

A problem occurred while - {{dataObj.progressMessage}}

2. Set up target vCenter Server and start services
2. Set up target PSC and start services

A problem occurred while - {{dataObj.progressMessage}}

3. Import copied data to target vCenter Server
3. Import copied data to target PSC

A problem occurred while - {{dataObj.progressMessage}}

Data transfer and appliance setup has been completed successfully. Click on the link below to get started. Press close to exit.

Appliance Getting Started Page

{{dataObj.redirectionUrl}}
A problem occurred during setup. Services might not be working as expected.
Setup is in progress. Services on this appliance are starting.
You have successfully setup this Appliance

A problem occurred while - {{dataObj.progressMessage}}

vCenter Server Appliance setup has been completed successfully. Click on the link below to get started. Press close to exit.

Platform Services Controller appliance setup has been completed successfully. Click on the link below to get started. Press close to exit.

Appliance Getting Started Page

{{dataObj.redirectionUrl}}

Your vCenter Server Appliance is deployed on a Virtula SAN cluster. However, this one-host cluster must be further configured in order to provide the full benefits of a Virtual SAN cluster.

Virtual SAN Configuration Instructions
  1. Add at least 3 more hosts to the cluster;
  2. Be sure all hosts have a network adapter enabled for VSAN traffic;
  3. Go to Configure >> Virtual SAN >> General and click Edit to complete the configuration of your new Virtual SAN cluster.